1 To begin with take out all the cut-out elements from the envelope and arrange them so that the side with a white square sticker is facing up |
2 Arrange the stickers on the t-shirt and once you achieve your desired composition take a picture of it for further reference |
3 Take off all the elements that are overlapping, you will later put them back on layer by layer referencing the photo that you took |
4 Cover the first layer of stickers with the special cloth that came with your sticker pack and gently but firmly press the iron over the stickers for 10 seconds. Make sure to that the steam option on your iron is off and the temperature regime is 160°C (three dots on your iron). Don't pull the iron over the cloth because that might cause the stickers to move |
5 Make sure all the elements are properly attached and remove the protective translucent cover from the all the stickers (if the elements didn’t adhere correctly cover them back up with the cloth and press with the iron for another few seconds) |
6 After completing the first layer, take a look at your reference photo and arrange the second layer of stickers accordingly. Repeat all the steps, remembering to remove translucent protective layer from the stickers before moving in to the next layer (we recommend to use maximum of 3 layers of overlapping stickers) |
7 After the whole composition is finished over it up once again with the protective close and iron everything all together one last time ding short pressing motions with the iron over entire composition |
8 After you’re done with the printing, don’t fold the t-shirt right away and let it cool off the prevent any wrinkling on the stickers. Item can be washed in 30°C water and ironed only inside out |